Roll Forming Machine,Welding Tube Mill,Slitting Line,Cut to Length Line

new products

Corrugated Fin Wall Production Line

Corrugated fin wall production line is for the production of fin walls for distribution transformer tanks. We have 1300 and 1600 two models of the machines making the corrugated walls with max. 1300/1600 mm wide, to cover the entire range of distribution and small power transformers. The production line mainly consists of Un-coiler, Fin folding machine, Fin seam welding machine, Spot welding machine, and Bending machine.

NEW

Step Lap Core Cutting Line

Step lap core cutting line is designed and built to produce transformer cores with step lap laminations. Multi step-lap construction is an advanced and green core design which suitable for high efficiency transformers. It can obviously improve the core performance, reduce no-load loss, sound level and magnetizing currents. The line has two punch and two cut, V notch can transverse moving driven by servo motor.

NEW

Core Stacking Table

The core stacking able is installed to stack the transformer laminations, assemble the core and to lift the core vertically. We offer 3-limb and 5-limb core table capacity from 3 ton to 450 ton, which suitable for distribution and power transformers. The limbs of the core stacking table can be easily adjusted by hand wheel to reduce setting time of adjusting limb center to center distance and window space of the Core. Adequate number of manual jacks are provided on the limbs for adjusting the level of the core. Adjustable stacking pin guides are equipped for different sizes core positioning. The tilting of stacking table from horizontal to vertical position is through hydraulic power lifting or overhead crane erection.

NEW

Vapor Phase Drying Plant

As of now, the most advanced drying technology for power transformer is the vapor phase drying method. Vapor phase drying is the method which applies vacuum but the heating is not through air. In this method the carrier of heat is vapor of low viscosity solvent like kerosene with a sufficiently high flash point instead of air. In vapor phase drying, the vapor is heated in a chamber by the use of electric heaters and is passed over the core coil assembly for drying.

NEW

Transformer Oil Filtration Machine

Transformer Oil Filtration Machine (Oil Purifier) is designed for filtration and purification of electrical insulating oil. It can remove water contents, gases and moistures, solid contaminations, recovering the oil dielectric strength (BDV), at the same time reducing the speed of oil ageing. The machine is very effective, durable, and user-friendly transformer insulating oil equipment. It is also applied for maintain oils used in other electrical equipment, such as regulator, reactor, circuit breaker, switchgear, etc.

NEW

Automatic Transformer Test Bench

The Automatic Transformer Test Bench is a desk type comprehensive testing system for routing test, type test and special test of distribution and power transformers, including automatic test capability for ratio-voltage, insulation resistance, DC resistance, no-load / load loss measurement, induced over voltage withstand test, temperature rise test, impulse voltage testing etc.

what we do

About Us

Services

WHY choose us

new products

Corrugated Fin Wall Production Line

Step Lap Core Cutting Line

Core Stacking Table

Vapor Phase Drying Plant

Transformer Oil Filtration Machine

Automatic Transformer Test Bench

Video Show

news

Exhibition News

Company News

Products News